Before and after engine mounts.

All the Diff Housing parts ready for assembly.

Centre plate attached to the welding jig, with the axle tubes welded to the plate.

Shows the alignment bar attached to the welding jig and the centre of the housing tacked on to the main plate.

Housing centre fully welded with the 4-bar brackets attached to the axle tubes.

New engine mounts in place set-up on the dummy block and gearbox.

New gearbox mount welded in and large hole in cross member filled.

The stainless steel 4-bar and panard rod adjustable ends full machined ready for welding.

Close fit for maximium strength.

Lots of amps and a skilled craftsman.......

The lid and flange for the in-tank pump on the custom alloy fuell cell.

[ Back ] [ Racecraft home ] [ Next ]